SilverCrest SPWE 180 A1 Mode D'emploi page 23

7.2 Auto Power Off
The bathroom scales have an automatic switch-off function (Auto Power Off function).
•
The bathroom scales switch off automatically about 10 seconds after you step off the tread (2).
•
If you do not step off the tread (2) after weighing yourself, the bathroom scales also switch off
automatically after approximately 10 seconds.
7.3 Replacing the battery
Replace the battery when it is empty. To replace the lithium battery
CR2032, open the cover of the battery compartment (4) at the rear of
the bathroom scales by slipping your finger into the slot on the side of the
battery compartment (4). Now remove the cover of the battery
compartment (4).
To remove the battery, push it down a bit (see the direction of the arrow
in the illustration). You can then remove the battery from the holder.
Then insert a new lithium battery CR2032. Pay attention to the
polarity when inserting the battery. This is indicated in the battery
compartment (4), and the + symbol on the lithium battery CR2032
must be visible, as shown in the adjoining illustration.
Then replace the cover on the battery compartment (4). The
bathroom scales are now ready to use.
8. Troubleshooting
8.1 Nothing is indicated on the LCD display
•
The lithium battery CR2032 is empty. Replace the lithium battery CR2032 with another of the
same type. Please note the instructions in the section "Replacing the battery".
•
The lithium battery CR2032 is inserted incorrectly. Please note the instructions in the section
"Replacing the battery".
SilverCrest SPWE 180 A1
English - 21