SilverCrest SPWE 180 A1
7. First use
7.1 Switching on the scales/measuring weight
The bathroom scales must be calibrated before first use or after having been
moved to ensure that they can determine one's weight exactly. To do so, step
briefly on to the tread (2), step off it again and wait until the bathroom scales
switch off automatically. The bathroom scales are now calibrated.
Due to the step on power function, the bathroom scales are switched on automatically when you
step on the tread (2) and they start to measure your weight immediately.
In their original state, the bathroom scales are set to the "kg" unit of weight. To change the unit of
weight, press the "Button for setting the unit of weight" (3). The selected unit of weight is then
indicated on the LCD display (1).
Stand on the tread (2) of the bathroom scales so that your weight is evenly distributed. Remain as
still as possible during the weighing process as the measurement result may be distorted otherwise.
The measurement result is indicated on the LCD display (1) during the weighing process. The
measurement is complete when the display flashes three times.
A solid surface is required to measure weight correctly. Thus always place the
bathroom scales on a solid, horizontal floor covering and never on carpet.
This can distort the measurement result.
To obtain comparable measurement results, you should always weigh yourself
if possible at the same time of day (preferably in the morning). Always weigh
yourself if possible under the same conditions: on an empty stomach, after
having gone to the toilet and naked.
Please note that values for the stone unit of weight are not represented as
decimal values. The display is divided into two segments by a colon. Only whole
numbers are displayed in the "st" unit of weight to the left of the colon. The
remaining weight is displayed in the "lb" unit of weight to the right of the colon.
Example: The display indicates "6: 8.0 st". This corresponds to 6st and 8lb.
20 - English