Preparing To Use The System; Mounting The Bar Speaker Or Rear Speaker (Not Supplied) On A Wall - Sony HT-Z9F Manuel D'instructions

Preparing to Use the System

Mounting the Bar
Speaker or Rear Speaker
(not supplied) on a Wall
You can mount the Bar Speaker or rear
speakers on a wall.
Bar Speaker
Notes
• Prepare screws (not supplied) that are
suitable for the wall material and
strength. As a plasterboard wall is
especially fragile, attach the screws
securely in the wall beam. Install the
speakers horizontally, hung by screws in
studs in a continuous flat section of the
wall.
• Have the installation done by a Sony
dealer or licensed contractor and pay
special attention to safety during the
installation.
• Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
disaster, etc.
Rear speakers
Mounting the Bar Speaker
on a Wall
1
Prepare two screws (not supplied)
that are suitable for the hole on
the wall mounting bracket
(supplied).
4 mm (3/16 in)
More than 30 mm
(1 3/16 in)
2
Stick WALL MOUNT TEMPLATE
(supplied) on a wall.
Center of the TV
Adhesive tape,
etc.
1
Align TV CENTER LINE () of
WALL MOUNT TEMPLATE with the
center line of your TV.
2
Align TV BOTTOM LINE () of
WALL MOUNT TEMPLATE with the
bottom of your TV, then stick
WALL MOUNT TEMPLATE on a
wall by using a commercially
available adhesive tape, etc.
Wall mounting bracket
WALL MOUNT
TEMPLATE
29
US