Preparing For Using The System; Mounting The Bar Speaker On A Wall - Sony HT-S100F Manuel D'instructions

Preparing for Using the System

Mounting the Bar
Speaker on a Wall
You can mount the Bar Speaker on a
wall.
Notes
• Prepare screws (not supplied) that are
suitable for the wall material and
strength. As a plasterboard wall is
especially fragile, attach the screws
securely in the wall beam. Install the
speakers horizontally, hung by screws in
studs in a continuous flat section of the
wall.
• Have the installation done by a Sony
dealer or licensed contractor and pay
special attention to safety during the
installation.
• Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
disaster, etc.
14
US
1
Prepare two screws (not supplied)
that are suitable for the wall
mount holes on the rear of the Bar
Speaker.
More than 30 mm (1 3/16 in)
Hole on the rear of the Bar Speaker
2
Stick WALL MOUNT TEMPLATE
(supplied) on a wall.
Center of the TV
Adhesive tape,
etc.
1
Align TV CENTER LINE () of
WALL MOUNT TEMPLATE with the
center line of your TV.
2
Align TV BOTTOM LINE () of
WALL MOUNT TEMPLATE with the
bottom of your TV, then stick
WALL MOUNT TEMPLATE on a
wall by using a commercially
available adhesive tape, etc.
4 mm (3/16 in)
5 mm
(7/32 in)
10 mm
(13/32 in)
WALL MOUNT
TEMPLATE