Publicité
Les langues disponibles
Les langues disponibles
11.
FRAME (Optional for IZ and Hydro models)
There is an accessory for the models of the IZ and Hidro families that you can
purchase and which can help you install the equipment quickly and comfortably, taking
into account that it can only be installed by qualified personnel.
The frame that you have purchased is a frame, compatible with all models of
the IZ family, on which we can install our equipment and thus be able to raise it above
the ground at different heights thanks to its possibility of adjustment with its extendable
legs. which have a versatility in height between 213 and 395 mm.
Below, we show a series of images that will allow us to proceed with its installation on the computer.
To assemble the bench, simply screw, with the help of 4 M8 x 16 mm screws and the 4 washers, the two
independent structures on each side of the base of the device, with the gaps coinciding between the base (with rivet
nut) and the structure of the bench itself.
The bench, as shown in the image, is height adjustable (maximum height and minimum height specified in the
corresponding technical sheet), to do so it is necessary to remove the M8 x 50 mm screws. that fix the legs in the
guides of the bench, and reassemble them in two different consecutive holes. It is important to give the same height
to all the legs, to ensure the stability of the device.
WARNING: Installation and/or uninstallation must be carried out by qualified personnel, taking into
account that if not, the manufacturer declines all responsibility for the person who carried out the
installation.
12.
STEEL LUMBER
Due to various circumstances, there are teams that have a woodshed
where they can store a certain amount of fuel while it is possible that the
equipment you have purchased does not have it. Therefore, you should keep
in mind that among the different accessories that are at your disposal, there is
equipment that is pre-designed so that an additional log holder can be attached
to it (See our catalog for more information), using it as a reference to its
incorporation some small tabs that will serve as positioners.
At a certain point in time, you may proceed to cut part of the woodshed
if required by its installation, always taking into account that its modification does not affect the mechanical resistance
required by the woodshed.
55
Publicité
