Publicité
Les langues disponibles
Les langues disponibles
WARNING: The manufacturer declines all responsibility if the control and use rules described
in this manual are not respected.
5.
FUNCTIONING. FIRST USE OF THE EQUIPMENT
- Before turning on for the first time, you must remove all accessories found inside the equipment, such as
the instruction manual, fireproof glove, and cold hands system.
- It is recommended to open a window to ventilate the room.
- For the ignition process of the stove, it is recommended to use paper, ignition tablets and small firewood
sticks. Once the fire starts working, add two sticks weighing 1 to 1.5 kg to the first load. During this lighting process,
the stove's air vents must be completely open, and if necessary, you can also help yourself, at the beginning, by
opening the ash drawer. Once the fire has gained intensity, regulate the intensity of the fire by closing the primary
air regulation and the chimney draft to a greater or lesser extent.
- To achieve the nominal power of this stove, you must place an amount of firewood weighing approximately
3.30 kg, at 1 hour intervals. The device should not be recharged until the previous charge has been consumed and
only the reserve of embers remains.
- The ashtray drawer, located inside the stove and behind the door, is used to remove ashes. Empty it often
without waiting for it to fill too much to avoid damaging the grill, be careful with the ash up to 24 hours later it can
still be hot.
- In the event of overheating, close the air vents to reduce the intensity of the fire.
- In case of malfunction, close the drafts and air regulations, and consult the point of sale.
- The doors of the combustion chamber and the ashtray must remain closed, except during ignition, refueling
and the removal of residual material, to avoid any escape of smoke.
- Keep air intake grilles free of blockage.
- The device is designed for intermittent and not continuous operation.
- In the event that your equipment has a built-in oven, you must take into account that, during the first times
the equipment is turned on, in the case of keeping the stainless steel tray(s) inside, it is necessary to pour a quantity
of water over them. that covers a minimum of 10 mm in height. This will prevent these trays from suffering
deformations in the future.
5.1.
Painting at First Lighting
- It is essential that the first ignition be done slowly, following the ignition procedure.
- During the first ignitions, the equipment should be loaded with a small amount of firewood, allowing it to
burn slowly. This fact causes the paint to adhere correctly to the metal and cross-link to adapt to the
expansions and contractions that the equipment will suffer during its useful life, preventing the paint
from losing properties.
- When the equipment is turned on for the first time, it may emit some fumes and gases, which is due to the
evaporation of the paint components and oils used in the manufacturing process.
- Anti-caloric paint has different characteristics than outdoor or water-based paint, it is a paint that can work
at high temperatures without being damaged, but it is weak when exposed to agents such as water or high levels
of humidity, as well as grease or abrasive cleaning products, and even more so if a correct procedure is not carried
out during the first ignitions.
5.2.
Cold Hand / Glove System
Due to the fact that there are parts of your equipment that reach high temperatures during its operation, a hook
that functions as a cold hand and a protective glove have been included in its equipment. It should be taken into
account that the use of these accessories does not exempt you from the fact that if you touch any component with
an excess of temperature, it could cause burns, so you must be careful when carrying out any type of manipulation.
44
Publicité
