Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT: The use of the equipment must always be carried out with the fans connected to
power, otherwise they may be damaged, an aspect that is not covered by the warranty at any time.
WARNING: Installation and/or uninstallation must be carried out by qualified personnel, taking into
account that if not, the manufacturer declines all responsibility for the person who carried out the
installation.
8.2.
Tangential Fan Kit
Within the range of products there are different models that mount a tangential fan, instead of the axial fans
mentioned in the previous point, which serve to channel the air if this is considered appropriate. On this occasion the
operation of the electronics that this kit has is as follows:
- Position 0: Off position.
- Position 1: The fans run continuously at slow speed.
- Position 2: The fans run continuously at fast speed.
The installation of the channeling nozzle(s) must be carried out as we have previously described in section
"8.1. Axial Fan Kit".
Below, we show a series of images where you can see the disassembly/assembly system of the tangential fan
belonging to the Kit discussed in this point. Likewise, you must take into account that the electrical cable must be
connected to the network. It is essential to correctly connect to the grounding installation and take into account that
when carrying out any type of manipulation of the kit, the system must be disconnected from the electrical current.
- Unscrew the screws on the tangential fan protective plate. This gives us direct access to our fan and
consequently to the electrical connections that it has, which we must carefully uninstall to avoid causing any type of
damage to them.
- Unscrew the screws that our fan has on both sides and which allow it to be attached to the equipment. After
this process we will see that our fan is completely free, which allows us to proceed to work on it to carry out
maintenance, verifications, etc...
WARNING: The installation must be carried out by qualified personnel, taking into account that if
this is not the case, the manufacturer declines all responsibility for the person who carried out the
installation.
8.3.
Ventilation Kit for IZ models
In the event that you have purchased one of the equipment that makes up the IZ family, you should know that
it is possible to adapt different VENTILATION KIT options depending on our needs.
If at any time, after the purchase and/or installation of the equipment, you decide to purchase it, you can do so
without any problem, always taking into account that it must be installed by a qualified technician and that said kit
requires space to be able to incorporate it.
Both kits include a control unit, with its corresponding remote control, to control its operation. When purchasing
them we will find a manual where the functions they offer us will be explained in detail, as well as how the electrical
connection must be made.
51
Publicité
