Faults - What To Do - Gaggenau RB282 Notice D'utilisation

Faults – what to do?
3
B efore you call customer service, use this table to check whether you can rectify the fault yourself.
F a u l t s – w h a t t o d o ?
Temperature differs greatly from the set value.
Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display indicates "E...".
Electronics have detected a fault.
A warning signal sounds and the Ú button is lit.
Appliance door is open.
Ventilation openings have been covered.
Large quantities of fresh food were placed in the appliance.
Display flashes, warning signal sounds and button Ú is lit.
Appliance door is open.
Ventilation openings have been covered.
Large quantities of fresh food were placed in the appliance.
Display flashes.
The temperature in the freezer compartment was too warm.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
Automatic fast freezing does not switch on.
--------
Switch off appliance for 5 minutes.
"Switching off and disconnecting the appliance"
~
on page 36
If the temperature is too warm, check temperature again after
a couple of hours.
If the temperature is too cold, check temperature again on the
following day.
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Call the after-sales service.
"Customer service" on page 48
~
Press the Ú button. Alarm is switched off.
Close the appliance door.
Clear ventilation openings.
Do not exceed max. freezing capacity.
Press the Ú button. Alarm is switched off.
Close the appliance door.
Clear ventilation openings.
Do not exceed max. freezing capacity.
When button Ú has been pressed, the warmest temperature
reached in the freezer compartment is displayed for 5 sec-
onds. Press the Ú button. The display stops flashing.
Start the appliance self-test.
"Appliance self-test" on page 48
~
When the programme has ended, the appliance switches
over to normal operation.
The appliance decides independently whether automatic fast
freezing is required and switches it on or off automatically.
Faults – what to do?
en
47