Electrolux 600 Serie Manuel D'utilisation Et D'entretien page 43

• When cleaning chrome parts, it is best to
use only a damp cloth.
• Before moving the dryer, place a strip of
cardboard or thin fi berboard under the
front leveling legs to prevent damage to
the fl oor.
WARNING
FIRE HAZARD
A clothes dryer produces combustible
lint. The dryer must be connected to an
outdoor exhaust. Regularly inspect the
outdoor exhaust opening and remove any
accumulation of lint around the opening
and in the surrounding area.
IMPORTANT
DO NOT store or place laundry products
on top of dryer at any time. They can
damage the fi nish or controls. It is
recommended to keep laundry products
in the storage drawer between cycles if
installed on a pedestal.
Water inlet hose
inspection
(steam models only)
Periodically inspect all water inlet hoses
for water leaks, wear, cuts, corrosion and
bulges. Replace all hoses, if any sign of the
above is visible. All hoses should be
replaced every 5 years to reduce the risk of
hose failures. When replacing hoses, refer
to the installation instructions for proper
installation. DO NOT overtighten or cross
CARE AND CLEANING
thread the fi ttings. DO NOT allow the hose
to rub against sharp objects. Always ensure
the hose fi tting rubber gasket is installed and
free from water leaks when water pressure is
applied.
Rubber Washers
Must Be Present
Limited use, vacation, and
away from home
CAUTION
Your dryer should be operated ONLY
when you are home. If you are away from
home or not using your dryer for extended
periods of time, follow these steps:
1. Turn off the water supply to dryer
(steam models only) to avoid water
leaks due to water pressure surges and
unforeseen occurrences in the water
supply.
2. Disconnect or unplug the electrical
power to the dryer.
Reconnecting water supply
and electrical
IMPORTANT
When reinstalling the dryer after
disconnecting the water supply lines
(steam models only) and electrical power,
please follow the steps below:
1. Review the installation instructions
provided with the dryer to ensure the
appliance is level and the water and
electrical power supply is properly
connected.
2. Ensure the water lines are fl ushed of
debris, prior to connecting the water
lines to the dryer inlet.
3. Check for water leaks and replace
supply hoses if needed.
43
USE ONLY
NEW HOSES