Electrolux 600 Serie Manuel D'utilisation Et D'entretien page 18

18
INSTALLATION
Connecting the electrical
system
The following are specifi c requirements for
proper and safe electrical installation of
your dryer. Failure to follow these instructions
can create electrical shock and/or a fi re
hazard.
WARNING
ELECTRICAL SHOCK HAZARD
• This appliance MUST be properly
grounded. Electrical shock can result
if the dryer is not properly grounded.
Follow the instructions in this manual for
proper grounding.
DO NOT use an extension cord with this
dryer. Some extension cords are not
designed to withstand the amounts of
electrical current this dryer utilizes and
can melt, creating electrical shock and/
or fi re hazard. Locate the dryer within
reach of the receptacle for the length
power cord to be purchased, allowing
some slack in the cord. Refer to the
Pre-Installation Requirements section of
this manual for the proper power cord
to be purchased.
WARNING
ELECTRICAL SHOCK HAZARD
• A U.L.-approved strain relief must be
installed onto power cord. If the strain
relief is not attached, the cord can
be pulled out of the dryer and can
be cut by any movement of the cord,
resulting in electrical shock.
DO NOT use an aluminum wired
receptacle with a copper wired
power cord and plug (or vice versa).
A chemical reaction occurs between
copper and aluminum and can cause
electrical shorts. The proper wiring and
receptacle is a copper wired power
cord with a copper wired
receptacle.

NOTE
Dryers operating on 208 volt power supply
will have longer drying times than dryers
operating on 240 volt power supply.
The dryer, when installed, must be
electrically grounded in accordance with
local codes and the National Electrical code
ANSI/NFPA 70 or the Canadian Electrical
Code, Part 1, CSA C22.1.
Grounding requirements - electric
dryer (USA)
WARNING
Improper grounding of the dryer may
cause serious injury or death. Check with
a licensed electrician if you are in doubt
as to whether the appliance is properly
grounded.
For a grounded, cord-connected
dryer:
1. The dryer MUST be grounded. In the
event of a malfunction or breakdown,
grounding will reduce the risk of
electrical shock by providing a path of
least resistance for electrical current.
2. After you purchase and install a 3-wire
or 4-wire power supply cord having
an equipment-grounding conductor
and a grounding plug that matches
your wiring system, the plug MUST be
plugged into an appropriate, copper
wired receptacle that is properly
installed and grounded in accordance
with all local codes and ordinances. If
in doubt, call a licensed electrician.
3 . DO NOT modify the plug you've
installed on this appliance. If it will
not fi t the outlet, have a proper outlet
installed by a qualifi ed electrician.
For a permanently connected
dryer:
The dryer MUST be connected to a
grounded metal, permanent wiring system;
or an equipment grounding conductor
must be run with the circuit conductors and
connected to the equipment-grounding
terminal or lead on the appliance.