Electrolux 600 Serie Manuel D'utilisation Et D'entretien page 40

40
OPERATING INSTRUCTIONS
STEPS
1. Select the
appropriate
cycle and
settings for
each load.
2. Close the
dryer door
and start the
drying cycle.
3. Remove
items when
done.
4. Clean the lint
fi lter.
TIPS
• See Cycle Selection and Cycle Settings for
detailed descriptions of cycle controls.
• See Cycle Setting Charts to determine which
settings are available for each cycle.
• To provide the best care, not every setting or
option is available with every cycle. If a setting
or option is not available for the cycle selected,
the indicator will not light. See Setting Chart for
information of available options for each cycle
by model.
• Adjustments made to most cycle settings will be
remembered each time the cycle is selected in the
future. When the dryer is powered on, the default
cycle will be the normal cycle. Select your desired
cycle and previous settings will remain. To return to
factory settings, press the dryness button and the
options button at the same time and hold until the
signal sounds.
To return to factory settings,
• To start the drying cycle, close the door and press
press the dry level/dryness and
options buttons at the same time
the start/pause button.
and hold until the signal sounds.
• To add an item to the dryer drum, press start/
pause. Add the item, close the door and press
start/pause to resume the cycle.
• To change settings or options after the cycle has
begun, press start/pause, change the settings, and
then press start/pause. If the cycle is not paused
fi rst, the unit will emit several beeps when the
buttons are pressed but no changes to the cycle
will be applied.
• To change the cycle once the cycle has begun,
press cancel to cancel the cycle, select the
new cycle, and press start/pause to begin the
new cycle. Changing a cycle selection without
cancelling the current WILL NOT change the cycle.
• To cancel a cycle, press cancel.
• A signal will sound at the end of the cycle if the
chime option is not set to mute.
• Immediately remove items when the cycle is
completed and hang or fold.
• See Care and Cleaning section of this instruction.
• CLEAN LINT will be displayed at the end of the
cycle as a reminder to remove lint from fi lter.
IMPORTANT
Over-drying can
cause wrinkles,
shrinkage, lint,
harshness, and a
build up of static
electricity.
To prevent
unintentional
and accidental
exposure of
delicate material
to excess heat
or unexpected
steam, the sanitize
temperature
setting and the
perfect steam™
option will not be
remembered and
must be reselected
each time.
The dryer will not
operate with the
door open.
When drying a
single large or
bulky item, such
as a comforter,
pause the cycle
part way through
to turn the item
"inside out" and
maximize drying
eff ectiveness.
See product
manufacturer's
instructions.
ALWAYS REMOVE
LINT at the end
of the cycle
(see warning on
previous page).