Electrolux 600 Serie Manuel D'utilisation Et D'entretien page 9

Exhaust Venting
 Free-fl owing, clear of lint buildup
 4 inch (102 mm) rigid metal or
semi-rigid metal transition ducting
of minimal length and turns
 NO foil or plastic venting material
 Approved vent hood exhausted to
outdoors
Leveling
 Dryer is level, side-to-side and front-
to-back
 Cabinet is sitting solid on all corners
Gas Supply (Gas Dryer)
 Manual shutoff valve present in supply
 All connections sealed with approved
sealer and wrench tight
 Conversion kit for LP GAS system
# PCK4200 (not included) and must be
purchased separately
 Gas supply turned on
 No leaks present at all connections -
check with soapy water, NEVER check
with fl ame
Water Hookup (Select Models)
 Inspect hoses for proper placement of
rubber washers
 Water supply is turned on
PRE INSTALLATION REQUIREMENTS

Installation Checklist
 Check for leaks
 Steam model dryers require use of
ASSEMBLY HOSE Kit #5304495002
(not included) and must be purchased
separately.
240v Electric Supply
(Electric Dryer)
 Approved NEMA 10-30 or 14-30 service
cord with all screws tight on terminal
block
 Approved strain relief installed
 Terminal access cover installed before
initial operation
Door Reversal
 Follow detailed instructions in this
manual
 Test hinge and latch for function
Electrical Power
 House power turned on
 Dryer plugged in
Final Checks
 Installation Instructions and Use & Care
Manual read thoroughly
 Door latches and drum tumbles when
cycle starts
 Registration card sent in
9