Electrolux 600 Serie Manuel D'utilisation Et D'entretien page 24

24
INSTALLATION
Completing the installation
1. Connect the exhaust duct to the
outside exhaust system. Use of
a 4" (102 mm) clamp (item A) is
recommended to connect the dryer to
the exhaust vent system. Use metal foil
tape to seal all other joints.
2. Use a carpenter's level to level your
dryer front-to-back and side-to-side.
3. Use adjustable pliers to adjust the
leveling legs so the dryer is level front-
to-rear and side-to-side, and stable
corner-to-corner.
4. Press down on alternate corners
and sides and feel for the slightest
movement. Adjust the appropriate
leg(s) so the dryer sits solidly on
the fl oor on ALL four legs. Keep the
leveling leg extension at a minimum for
best performance of the dryer.
IMPORTANT
Be sure the power is off at a circuit
breaker/fuse box before plugging the
power cord into an outlet.
5. Plug the power cord into a grounded
outlet.
WARNING
Improper grounding of the dryer may
cause serious injury or death. Check with
a licensed electrician if you are in doubt
as to whether the appliance is properly
grounded.
1
2
WARNING
Do not store combustible materials,
gasoline, and other fl ammable vapors and
liquids near this dryer.
6. Turn on the power at the circuit
breaker/fuse box.
7. Read the Use & Care Manual provided
with the dryer. It contains valuable and
helpful information that will save you
time and money.
8. If you have any questions during initial
operation, please review the "Avoid
Service Checklist" in your Use & Care
Manual before calling for service.
9. Place these instructions in a location
near the dryer for future reference.

NOTE
A wiring diagram and technical data sheet
are located under the dryer top panel.
CAUTION
When discarding or storing your old dryer,
remove the door.