mundoclima MUPR-H14 Serie Manuel D'installation Et L'utilisauter page 109

ECO/GEAR function
Press X-ECO button to enter the energy efficient mode in a sequence of
following:
ECO
Note:This function is only available under COOL mode.
ECO operation:
Under cooling mode, press this button, the remote controller will adjust the temperature
automatically to 24 C/75 F, fan speed of Auto to save energy (only when the set temperature
O
O
is less than 24 C/75 F). If the set temperature is above 24 C/75 F, press the ECO button,
O
the fan speed will change to Auto, the set temperature will remain unchanged.
NOTE:
Pressing the ECO button, or modifying the mode or adjusting the set temperature to less
than 24 C/75 F will stop ECO operation. O
O
Under ECO operation, the set tmeperature should be 24 C/75 F or above, it may result in
insufficient cooling. If you feel uncomfortable, just press the ECO button again to stop it.
GEAR operation:
Press the ECO/GEAR button to enter the GEAR operation as following:
75% (up to 75% electrial energy consumption)
50% (up to 50% electrial energy consumption)
Previous setting mode.
Under GEAR operation, the display on the remote controller will alternage between
electrical energy consumption and set temperature.
GEAR(75%) GEAR(50%)
O
109
Previous setting mode
O
O
O
O
ECO......