Publicité
Les langues disponibles
Les langues disponibles
The shower function ensures greater DHW Comfort, for example during a shower.
This function allows you to draw hot water at a lower temperature than the nominal temperature value.
To modify the maximum temperature value of the shower function, proceed as described in section 4.3.
This function may be manually activated as follows:
•
Press one of the two buttons +/- (
pear on the display for a few moments, followed by the letters HW SS);
•
press OK while the delivery temperature and the symbol
•
the duration of the function is 60 minutes (during this period the symbol
At the end of this period the DHW temperature returns to the value of the operating mode set before the function (on
the display the symbol
N.B.:
to disable the function before 60 minutes have elapsed, proceed as follows:
•
press one of the two buttons +/- (
press OK, the display shows the letters "HW S^ ".
•
4.3 CHANGING THE TEMPERATURE VALUES OF THE FUNCTIONS ASSOCIATED WITH THE BUTTON
To modify the temperature value, proceed as follows:
•
Press IP to activate the PROGR function;
•
use the button
to scroll through the functions to be changed as described in the following table:
Function
Display
The set temperature value
COMFR
flashes (factory value = 20°C)
The set temperature value
ECONM
flashes (factory value = 18°C)
The set temperature value
NOFRS
flashes (factory value = 5 °C)
The set temperature value
SHOWR
flashes (factory value = 40°C)
•
To change the value of the selected function, press +/-
•
To exit, press IP
4.4.1 TIMED SHUTDOWN OFF (HOLIDAY PROGRAMME)
With this function it is possible to inhibit the timed programming temporarily (section 3.6) for a certain period. In this phase
a minimum ambient temperature is guaranteed (factory value 5°C) which may be modified as described in section 4.3
under the heading "NOFRS".
To activate the function, proceed as follows:
•
press the button
to set "AUTO" function (symbol
, the letters MM 60 appear on the display and the symbols
•
press the button
INSTRUCTIONS FOR USERS
4.2 SHOWER FUNCTION
) and then press the button
stops blinking).
) and then press the button
Function description
Boiler in heating mode at rated temperature
Boiler in heating mode at reduced temperature.
Boiler in heating mode at preset antifreeze ambient temperature.
Boiler in DHW mode at the preset temperature.
4.4 TIMER FUNCTIONS (BUTTON
to activate the function (the letters SHOWR ap-
are blinking on the display;
blinks).
;
;
)
);
11
blink.
7864176 - en
Publicité
