Planing - HOLZMANN MASCHINEN HOB 260ABS Mode D'emploi

17.7 Planing

The unused part of the planing shaft must be covered by the cover. Never touch the
edges of the workpiece with your fingers, but always leave both hands on the
workpiece with your fingers when planing. If the workpiece is short and narrow, use
the sliding stick.
Only plane workpieces that rest firmly on the machine and that can be guided safely!
HOLZMANN MASCHINEN GmbH
WARNING
 Fix the planer fence (1) in the desired working
 Set the desired cutting depth on the adjusting
 Adjust the blade guard (3) so that the distance
 Start the machine on by pressing the ON-button.
 Press the workpiece against the entry planer table
 With the second hand (5), push the workpiece
 After finisching the operation, switch off the
www.holzmann-maschinen.at
 The desired cutting depth is set with
the adjusting screw (12), which is
located at the front of the entry planer
table (13).
 With the aid of the scale (14), the set
cutting depth can be read off. A
cutting depth between 0.5 and 1.5 mm
(1/64~1/16 in.) provide the best
surface quality.
 Fix the planer fence (15) in the
desired working position with the fixing
lever (16).
 The angular adjustment of the planer
fence is fixed with the angular fixing
lever (17).
 Adjust the blade guard (18) so that
there is a distance of approx. 5 mm
between the guard and the workpiece.
position.
screw (2).
between the cover and the workpiece is approx.
5mm.
with one hand (4).
slowly and evenly over the shaft.
machine by pressing the OFF-button.
OPERATION
47
HOB 260ABS