Thicknessing; Working Conditions For Thicknessing; Converting Machine To Thicknessing Function - HOLZMANN MASCHINEN HOB 260ABS Mode D'emploi

17.8 Thicknessing

It is necessary to modify/adjust the machine before using as a thicknesser.
Before carrying out any modification, the machine must be switched off and secured
against being switched on again.

17.8.1 Working conditions for thicknessing

Long, protruding workpieces must be sufficiently supported! Use suitable aids such as

roller blocks etc. for this purpose. If you do not follow these instructions, there is a danger
of the workpiece being raised up quickly and/or the machine being tilted!
 Use the thicknessing function only to reduce the thickness of a workpiece with an already
surface planed facing!
For workpieces with a difference in thickness, the chip removal must be measured at the

maximum thickness and the workpiece machined with this side first.
 Make sure that the workpiece to be machined is free of foreign objects and/or knots in
order to avoid dangerous fractures.
Only plane workpieces that rest firmly on the machine and can be guided safely!

If several workpieces are to be processed in series, all pieces of the same thickness should

be run through in succession without changing the setting.
 Perform the machining process from the beginning until the desired thickness is achieved.

17.8.2 Converting machine to thicknessing function

HOLZMANN MASCHINEN GmbH
NOTICE
WARNING
1. Disassembly planer fence
www.holzmann-maschinen.at
 First remove the planer fence (1) by loosening
the fixing lever (2).
 To dismantle the dust collector in the position for
planing, pull out the two brackets (6).
OPERATION
49
HOB 260ABS