Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Operation
Control panel
A
1
2°C indicator
2
4°C indicator
3
6°C indicator
A
Temperature setting button
Note: Do not use sharp objects to operate the control
panel. They can scratch or damage the control panel.
Switching on
When you connect the mains plug to a power socket,
the appliance switches on and starts operating.
Display
In case of a temperature sensor failure, the
corresponding indicators will blink.
Indicator status
Both the 2°C and 4°C
indicators (
1
and
2
) are
blinking.
Both the 4°C and 6°C
indicators (
2
and
3
) are
blinking.
Note: If there is a flashing failure, please call the
service center.
Setting the temperature
Recommended temperature
Refrigerator compartment: +4°C (factory setting)
• You can set the temperature of the refrigerator
compartment via the control panel.
• You cannot directly set the temperature of
the freezer compartment. But the colder the
refrigerator compartment, the colder the freezer
compartment.
• When the appliance is plugged in for the first time,
it sets the temperature to 4°C. When you plug
in or switch on the appliance again, it sets the
temperature to the last set temperature.
1
2
3
Fault
Refrigerator temperature
sensor failure
Ambient temperature
sensor failure
To set the temperature, press the temperature setting
button
one or more times until the indicator for
A
the desired set temperature lights up. The appliance
will operate according to the new set temperature in
30 seconds.
2°C
Tips:
• The lower the set temperature, the longer you can
safely store your food and the more electricity the
appliance consumes.
• The higher the set temperature, the quicker your
stored food decays and the less electricity the
appliance consumes.
Super cooling mode
• To put the appliance into super cooling mode,
press and hold the temperature setting button
for 3 seconds. Both the 2°C and 4°C indicators light
up and the appliance enters super cooling mode in
30 seconds.
3s
• The appliance will automatically exit super cooling
mode after 6 hours. To exit this mode earlier, press
the temperature setting button
Super freezing mode
• To put the appliance into super freezing mode,
press and hold the temperature setting button
for 6 seconds. Both the 4°C and 6°C indicators light
up and the appliance enters super freezing mode
in 30 seconds.
6s
• The appliance will automatically exit super freezing
mode after 24 hours. To exit this mode earlier,
press the temperature setting button
Switching off
To switch off the appliance, disconnect the mains plug
from the power socket.
4°C
6°C
.
A
.
A
12
A
A
Publicité
