Publicité
Les langues disponibles
Les langues disponibles
Danger!
• Handle a damaged or leaking battery with
extreme care and dispose of it properly and
immediately. Wear gloves to handle the
battery.
• If you come into contact with battery acid then
wash the affected area with soap and water.
If battery acid gets in your eye rinse it out with
water and seek medical help immediately!
• Do not short-circuit the terminals.
Inserting/replacing batteries
WARNING! Follow these instructions to
avoid mechanical and electrical dam-
age.
There are three batteries in the motion sensor (2)
and two batteries in the light sensor (3). Insert
the batteries (4) included in the delivery before
first using the chassis (1).
Chassis (fig. B)
Insert the batteries (4) included in the delivery
into the battery compartment (1c) of the chas-
sis (1) as follows:
1. Using a suitable screwdriver (not supplied)
loosen the screw (1b) on the battery compart-
ment lid (1a) on the bottom of the chassis (1)
and remove it.
2. Carefully place the batteries into the battery
compartment (1c). The batteries must be fully
seated in the battery compartment.
Note: Pay attention to the plus/minus polarity
of the batteries and their correct installation.
3. Screw the battery compartment lid (1a) back
tight on the bottom.
Replacing batteries
If the batteries stop working, replace them using
the same process as described for inserting
them. Remove the batteries already in the prod-
uct before inserting the new batteries.
Motion sensor and light sensor
(fig.C)
Before first use remove the plastic tongues (2a, 3a)
from the battery lids (2b, 3b) of the motion
sensor (2) and the light sensor (3).
18
GB
If the batteries inside no longer work, replace
them as follows:
1. Using a suitable screwdriver loosen the
screw (2c, 3c) on the battery compartment
lid (2b, 3b) and remove it.
2. Take out the batteries inside the product.
3. Carefully place new batteries into the battery
compartment (2d, 3d). The batteries must be
fully seated in the battery compartment.
Note: Pay attention to the plus/minus polarity
of the batteries and their correct installation.
4. Screw the battery compartment lid (2b, 3b)
back on tight.
Using the modelling clay
• Before and after each use of the clay wash
your hands thoroughly.
• Knead any modelling clay that has hardened
or been tempered until it is pliable again.
Warning: Do not mix the clay with
water!
• Always use a suitable waterproof pad to pro-
tect surfaces such as tabletops, floorings, etc.
• Do not use the product on doors, windows or
tiles.
• Make sure that the product does not come
into contact with textiles such as clothing,
carpets, upholstered furniture, etc.
• When not in use put the clay back into the
cans and close them.
Shaping the vehicle (fig. D)
1. Work the clay to form a vehicle of any shape
you choose.
2. Use the accessories to complete your vehicle
3. Plug a suitable accessory onto the motion
sensor (2) or the light sensor (3).
4. Place the motion sensor or the light sensor on
your vehicle.
Note: If the sensor on the chassis (1) comes
into contact with clay, the chassis is set in motion.
If the motion sensor (2) comes into contact with
clay, the upper part of the motion sensor turns.
If the light sensor (3) comes into contact with
clay, the LED in the upper part of the light sensor
lights up and flashes. After a period of time the
features switch off automatically.
Publicité
