Helios EDR Instructions De Montage Et D'utilisation page 33

Installation and Operating Specification EDR
7.2 Start-up
Procedure
1. You must mount and connect the device in accordance with
the operating instructions.
2. Double check that all connections are correct.
3. The supply voltage must match the information on the rating
plate.
4. Set the mode, unit and measuring range and adjust the sensor
in the BASE SETUP.
5. For the modes
parameters for control operation.
Information
When saving the Operating Mode, the factory settings are stored.
Therefore all the settings you have made, are lost.
7.3 Menu structure
100 Pa
Δp
Selection of the menu group (e.g. BASE SETUP) to the right
through the ▼-key, to the left through the ▲-key.
Youcangotothemenuitemsinthemenugroups (e.g. mode) by using
the P key. Use the arrow keys to move up and down within the
menu group.
To make adjustments, press the P key after selecting the menu
item. If the previously set value starts to flash, it can be adjusted
with the ▼ + ▲ keys and then saved with the P key. To exit the
menu without making any changes, use the "Esc" short-key, i.e.,
the originally set values remain.
L-BAL-E292-GB 2023/51 Index 002
.. and
4.01
Display after turning on the voltage supply.
Switch over between actual value display and
"INFO" with the key shortcut for Escape (Esc
= ▼ + ▲).
Part.-No.
.. set under SETTING the
5.01
12/21
Programming
INFO