Helios EDR Instructions De Montage Et D'utilisation page 28

Installation and Operating Specification EDR
3.2 Storage
The device must be stored in its original packaging in a dry and
•
weather-proof room.
Avoid exposure to extreme heat and cold.
•
Avoid over-long storage periods (we recommend a maximum of
•
one year).
3.3 Disposal / Recycling
Disposal must be carried out professionally and in an environ-
mentally friendly way in accordance with the respective national
legal stipulations.
"Separate the materials by type and in an environmentally-
friendly way.
"If necessary, commission a specialist company with the waste
disposal.
4 Mounting
Before installation remove the device from the packing and
•
check for any possible shipping damage!
Assemble the device on a clean and stable base. Do not distort
•
during assembly! Use the appropriate mounting devices for
proper installation of the unit!
Use the templates printed on the device packing to mark the
•
fastening bore holes.
The pressure measuring depends on position, therefore the
•
mounting must be made vertical and as possible on a vibration-
free place (cable inlet and pressure connections down).
The pressure line´s connection should be with plastic-hose (in
•
building), inside diameter 4 / 5 mm. For a firm hold of the hose,
its inside diameter must be 1 mm smaller than the outside
diameter of the hose nozzle (step spigot 5 / 6 mm).
Remove the connection cover for mounting and electrical con-
•
nection. Close the lid again carefully before start-up (tightening
torque of the lid screws 1.1 Nm).
L-BAL-E292-GB 2023/51 Index 002 Part.-No.
7/21
Mounting