Helios EDR Instructions De Montage Et D'utilisation page 32

Installation and Operating Specification EDR
7 Programming
7.1 Select operation mode
Information
Simple installation is possible through the selection of the
preprogrammed mode of operation.
This determines the basic function of the device, factory set
Mode
Pressure sensor output 0...10 V proportional to measuring range
4.00
Pressure controller (PID): output 0...10 V depending on adjusted
4.01
Setpoint and measured actual value.
Air volume sensor: Output 0...10 V propotional to measuring range
5.00
(depending on setting for K-Factor)
Air volume controller (PID): Output 0...10 V depending on adjusted
5.01
Setpoint and measured actual value
L-BAL-E292-GB 2023/51 Index 002
Function
Part.-No.
11/21
Programming
.
4.01