Helios EDR Instructions De Montage Et D'utilisation page 29

Installation and Operating Specification EDR
Vertical mounting
5 Electrical installation
5.1 EMC-compatible installation of control lines
Pay attention to maintain sufficient distance from powerlines and
motor wires to prevent interferences.
When using a shielded cable the shield must be connected (as
short and with as low an induction as possible!) to the PE conduc-
tor on one side at the signal input (of the evaluation unit).
5.2 Connection Voltage supply
Connection Voltage supply at terminals: "+U
must be strictly observedt hat the mains voltage lies within the
llowable olerance pecifications (see Technical data and nameplate
affixed to the side).
Danger due to electric current
Only PELV current sources which ensure safe electrical isolation
of the operating voltage in accordance with IEC/DIN EN 60204-1
must be used.
There is no potential isolation between supply voltage and output
signal.
L-BAL-E292-GB 2023/51 Index 002
Schraube
max
screw max
4,5 mm
Drilling template on packing
Part.-No.
8/21
Electrical installation
Bohrschablone
drilling template
4,5 mm
91 mm
Gehäuse / housing
106 mm
" and "GND". Here, it
S