Publicité
Les langues disponibles
Les langues disponibles
(6) LOSSNAY setting (CITY MULTI only)
This setting is required only when the operation of CITY MULTI units is interlocked with LOSSNAY
units. This setting is not available for the M/P-series units. Interlock settings can be made for the
indoor unit to which the remote controller is connected. (They can also be confirmed or deleted.)
Note:
· Use the centralized controller to make the settings if it is connected.
· To interlock the operation of the indoor units with the LOSSNAY units, be sure to interlock the addresses of ALL
indoor units in the group and that of the LOSSNAY unit.
[Button operation]
1 When "Lossnay" on the Settings menu is selected, the remote controller
will automatically begin searching for the registered LOSSNAY
addresses of the currently connected indoor unit.
2 When the search is completed, the smallest address of the indoor units
that are connected to the remote controller and the address of the
interlocked LOSSNAY unit will appear. "--" will appear if no LOSSNAY
unit is interlocked with the indoor units.
If no settings need to be made, press the
to the Settings menu.
To make LOSSNAY interlock setting
3 Enter the addresses of the indoor unit and the
LOSSNAY unit to be interlocked, with the
through
F4
buttons, select "Set" in the
"Function", and press the
button to save the settings. "Sending data"
will appear on the screen. If the setting is
successfully completed, "Setting completed"
will appear.
To search for the LOSSNAY address
4 Enter the address of the indoor unit to which
the remote controller is connected, select
"Conf" in the "Function", and press the
SELECT/HOLD
button. "Collecting data" will
appear on the screen. If the signal is received
correctly, the indoor unit address and
LOSSNAY address will appear. "--" will
appear when no LOSSNAY unit is found.
"Unit not exist" will appear if no indoor units
that are correspond to the entered address
are found.
RETURN
F1
SELECT/HOLD
– 26 –
button to go back
Publicité
