Publicité
Les langues disponibles
Les langues disponibles
(1) Test run (CITY MULTI and M/P-series)
Select "Test run" from the Service menu to bring up the Test run menu.
• Test run: Select this option to perform a test run.
• Drain pump test run: Select this option to perform a test run on the
Applicable only to the type of indoor units that support the test run
function.
Note: Refer to the indoor unit Installation Manual for the detailed information
about test run.
(2) Collecting the model names and serial numbers (M/P-series only)
The model names and the serial numbers of the indoor and outdoor units can be imported into the
remote controller.
[Button operation]
1 Select "Input maintenance info." from the Service menu to bring up the
Maintenance information screen.
2 Select "Collect model names and S/N".
The model name will be displayed on the remote controller after the
model names and the serial numbers have been collected.
Press the
F4
button to switch the display between the model name
and the serial number.
Note:
· The model names and serial numbers cannot be collected immediately after the
power is turned on. Wait for approximately 10 minutes until the remote
controller is ready to collect data.
· It may take more than 10 minutes when certain functions are selected or when
an error occurs.
· It may take approximately one minute for the remote controller to collect data.
· This function may not be available on some indoor units. Refer to the catalog
for details.
drain pump on the indoor unit.
– 22 –
Data cannot be collected for
approximately 10 minutes
after the power is turned on.
Publicité
