Publicité
Les langues disponibles
Les langues disponibles
(3) Input maintenance information
Select "Input maintenance info." from the Service menu to bring up the
Maintenance information screen. Refer to the indoor unit Installation
Manual for how to make the settings.
Note: The following settings can be made from the Maintenance information
screen.
·Registering model names and serial numbers
Enter the model names and serial numbers of outdoor and indoor units.
The information entered will appear on the Error information screen.
Model names can have up to 18 characters, and the serial numbers can
have up to 8 characters.
·Registering dealer information
Enter phone number of a dealer. The entered information will appear on
the Error information screen. Phone number can have up to 13
characters.
·Initializing maintenance information
Select the desired item to initialize the model name, serial number, and
dealer information settings.
(4) Function setting (CITY MULTI)
Make the settings for the indoor unit functions via the remote controller as
necessary.
Select "Function setting" from the Settings menu to bring up the Function
setting screen.
[Button operation]
1 The Function setting screen will appear.
Press the
or
F1
F2
setting number, or setting value. Then, press the
desired settings.
2 Once the settings have been completed, press the
button.
A screen will appear that indicates that the settings information is being
sent.
To check the current settings of a given unit, enter the setting for its M-
NET address and function setting number, select Conf for the Function,
and press the
SELECT/HOLD
A screen will appear that indicates that the settings are being searched
for. When the search is done, the current settings will appear.
3 When the settings information has been sent, a screen will appear that
indicates its completion.
To make additional settings, press the
screen shown in Step 2 above. Set the function numbers for other
indoor units by following the same steps.
Note:
· Refer to the indoor unit Installation Manual for information about the factory settings of indoor units,
function setting numbers, and setting values.
· Be sure to write down the settings for all functions if any of the initial settings has been changed after the
completion of installation work.
button to move the cursor to one of the following: M-NET address, function
button.
RETURN
– 23 –
or
button to change the settings to the
F3
F4
SELECT/HOLD
button to return to the
Publicité
