Publicité
Les langues disponibles
Les langues disponibles
5 Install the bottom case.
■ Installation using a switch box
• Secure at least two corners of the switch box with screws.
■ Direct wall installation
• Thread the cable through the groove.
• Secure at least two corners of the remote controller with screws.
• Be sure to secure top-left and bottom-right corners of the remote controller (viewed from the
front) to prevent it from lifting. (Use molly anchor etc.)
■ Installation using a switch box
Double switch box
Roundhead cross
slot screws
Important
To avoid damage to the controller, do not
overtighten the screws.
6 Cut out the cable access hole.
■ Direct wall installation (when running the cable along the wall)
• Cut out the thin-wall part on the cover (the shaded area in the right
figure) with a nipper.
Notice
Note that accidentally touching the circuit
board may damage the circuit board when
cutting out a cable access hole.
7 Connect the connector to the top case.
Connect the connector on the bottom case to the socket on the top case.
Important
To prevent malfunctions, do not remove the
protective sheet or the circuit board from the
top case.
Seal the cable access
hole with putty.
Wood
screws
Refer to 2.
Remote controller
cable
Refer to 4.
To avoid damage to the controller, do not make
holes on the controller cover.
Connect the
connector.
To prevent cable breakage and malfunctions,
do not hang the top controller casing hang by
the cable as shown in the figure above.
– 11 –
■ Direct wall installation
Remote controller
cable
Refer to 4.
Thread the cable
through the groove.
Publicité
