Clipster FarmClipper Akku2 Mode D'emploi page 25

• Battery cartridge is automatically stopped when the output power is low ( output voltage is less than 8 V) .
• Shearing time: approx . 60 - 90 min depending on the age of the battery, coat / wool conditions, the shearing plate
grinding and the blade pressure .
CAUTION:
• Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on
the tool .
5.4 Charging
• Plug the battery charger into the proper AC voltage source . The charging light will flash in green color .
• Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides
as their respective markings on the charger . Insert the cartridge fully into the port so that it rests on the charger
port floor .
• When the battery cartridge is inserted, the charging light color will change from green to red and charging will begin .
The charging light will remain lit steadily during charging .
• When the charging light color changes from red to green, the charging cycle is complete .
• If you leave the battery cartridge in the charger after the charging cycle is complete, the charger will switch into its
"trickle charge (maintenance charge)" mode .
• After charging, unplug the charger from the power source .
• A full charge takes around 90 minutes .
NOTE:
• The battery charger is for charging FarmClipper battery cartridge . Never use it for other purposes or for other
manufacturer's batteries .
• When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time,
it may not accept a full charge . This is a normal condition and does not indicate a problem . You can recharge the
battery cartridge fully after discharging it completely and recharging a couple of times .
• If you charge a battery cartridge from a just operated tool or a battery cartridge which has been left in a location
exposed to direct sunlight or heat for a long time, the charging light may flash in red color . If this occurs, wait for a
while . Charging will begin after the battery cartridge cools . The battery cartridge will cool faster if you remove the
battery cartridge from the battery charger .
• If the charging light flashes alternately in green and red color, charging is not possible . The terminals on the charger
or battery cartridge are clogged with dust or the battery cartridge is worn out or damaged .
6. Environmental protection and disposal
The user is responsible for the appropriate disposal of the shear blades and clipper after their
service life . Observe your local pertinent regulations . Do not dispose of the appliance with domestic refuse .
As part of the EU Directive governing the disposal of electric and electronic appliances, the appliance is
accepted free of charge by local waste collection points or recycling centers . Correct disposal will ensure environment
protection and prevent a potential harmful impact on people and the environment .
25