Clipster FarmClipper Akku2 Mode D'emploi page 24

5.2 Malfunction lists
Contact an authorised service department to repair not listed malfunctions .
Motor component
Motor does not work
Motor heats up
Motor runs
very slowly
Motor vibrates
Motor makes very loud
running noises
Clipper head
Upper plate does not
move
Upper plate does not
move over the entire
contact surface
Blades cut badly
Blades do not cut
Clipper head
gets very hot
5.3 Replace battery cartridge
• Always switch off the tool before insertion or removal of the battery cartridge .
• To remove the battery cartridge, withdraw it from the clipper while pressing the buttons on both sides
of the battery cartridge . (Figure 7)
• To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into
place . Always insert it all the way until it locks in place with a little click . If not, it may
accidentally fall out of the tool, causing injury to you or someone around you .
• Do not use force when inserting the battery cartridge . If the battery cartridge does not slide in easily,
it is not being inserted correctly .
• A full charge takes around 90 minutes .
Cause
Battery empty
- Switches or motor defective
- Supply air covers clogged
- Shear blade tension too high
- Defective motor
- Battery almost empty
- Rotor runs untrue
- Bearings are worn out
- Fan wheel broken
- Bearing defective
Cause
- Transmission defective
- Eccentric worn
- Eccentric shaft defective
- Upper blade or lower blade are blunt
- Blades haven't been sharpened well
- Shear blade tension too low
- Eccentric defective
- Transmission defective
- Clipper head worn out
- Shear blade tension too high
- Shear blade and/or eccentric without
lubricating film
Troubleshooting
Charge/change the battery
* Have replaced by specialised workshop
Clean or replace supply air covers
Tighten tension screw less . Replace the
blades, if they then don't cut anymore
* Have replaced by specialised workshop
Charge/change the battery
* Have replaced by specialised workshop
* Have replaced by specialised workshop
* Have replaced by specialised workshop
* Have replaced by specialised workshop
Troubleshooting
* Have replaced by specialised workshop
* Have replaced by specialised workshop
* Have replaced by specialised workshop
* Have specialised workshop resharpen blades
* Have specialised workshop resharpen blades
Increase tension with tension screw
* Have replaced by specialised workshop
* Have replaced by specialised workshop
* Have replaced by specialised workshop
Reduce shear blade tension, poss . resharpen
blades and relubricate with SAE 30 HD oil
24