OHAUS Adventurer Serie Guide De L'utilisateur page 11

4.2 Using the Balance
Note: Before using any application, be sure the balance has been leveled and
calibrated.
Weighing Application
1. If required, place an empty container on the pan and press Tare.
2. Add sample to the pan or container. The display shows the weight of the
sample.
5. MAINTENANCE
5.1 Cleaning
WARNING: Electric Shock Hazard. Disconnect the equipment from
the power supply before cleaning.
Make sure that no liquid enters the interior of the instrument.
Attention: Do not use solvents, harsh chemicals, ammonia or
abrasive cleaning agents.
The housing may be cleaned with a damp cloth and mild detergent if necessary.
5.2 Service Information
For troubleshooting common problems, download the user manual from
www.Ohaus.com. If the issue persists, please visit our website for available support
and service centers at https://www.ohaus.com/en-us/support/service-centers.
6. LEGAL for TRADE
MEASUREMENT CANADA AND NTEP CERTIFIED BALANCES
LEGAL FOR TRADE SETTING AND SEALING
When the balance is used in trade or a legally controlled application, it must be set
up, verified and sealed in accordance with local weights and measures regulations.
It is the responsibility of the purchaser to ensure that all pertinent legal requirements
are met. As the requirements vary by jurisdiction, the purchaser is advised to
contact their local weights and measures office for instructions about putting the
balance into service.
6.1 Settings
Place the balance in the location of use, level the balance and perform the following
steps:
1. For models with selectable graduation size, set the desired value in the
Graduations menu.
a) Press Menu on the main screen.
b) Press Balance Setup on the Main Menu screen.
c) Press Graduations on the Balance Setup screen.
d) Press the desired graduation size.
EN-7