HumanTechnik lisa signolux Receiver T Mode D'emploi page 17

Reset to factory defaults
Delete the pairing of each event icon (see „Deleting transmitters").
When all previously assigned transmitters have been removed from the memory of the receiver,
the preset transmitter indication is restored and the transmitters are automatically displayed.
Linking transmitter alerts with event icons
Up to 8 transmitters can be assigned to each event icon. This is achieved by pairing a trans-
mitter with an icon of your choice. Please keep in mind that a transmitter can only be paired if it
is not already stored in the memory of the receiver. If required, you might first have to delete
the transmitter from the memory (see "Deleting transmitters").
a) Keep the function button »
sequence. Let go of the button as soon as the desired icon is lit.
b) Trigger your transmitter (e.g. operate the doorbell pushbutton or test button).
c) Wait for about 20 seconds, then test the function by triggering the transmitter again.
Setting the melody
You can freely set every provided tone to an event icon of your choice. The mode selector
switch must be either set to 0 or 1.
a) First trigger an alert (e.g. operate doorbell pushbutton).
b) The icon assigned to the transmitter lights up and the previously chosen tone should be
heard.
c) Press and hold the melody setting button »♫« (5) for two seconds.
Let go of the button and press it repeatedly until you have found the desired melody
(you can choose from 16 different tones).
d) Once the icon ceases to flash, the selected tone has been set.
Deleting transmitters
Do the following if you wish to delete a transmitter from the device memory:
a) Keep the function button »
sequence. Let go of the button as soon as the icon in question is lit.
b) Now press the function button »●« and the melody button »♫« (3)+(5) at the same time.
All icons briefly light up and the transmitter is deleted from that icon.
Please note: This procedure will delete all transmitters assigned to this event icon.
●«
(3) pressed for some time. The event icons start to light up in
●«
(3) pressed for some time. The event icons start to light up in
English 17