Olimpia splendid OS-SEPHH09EI Mode D'emploi Et D'entretien page 90

3.7.3 - Setting combined timer
(Simultaneous setting of the ON and OFF timers)
TIMER OFF > TIMER ON (figures 33, 34 and 39)
(on => Stop => Start functioning)
this function is useful if the air conditioner is to be switched off after going to bed and switched back on in
the morning or when returning home.
Example:
the time is 20:00. if the air conditioner is to be switched off at 23:00 and switched back on at 06:00.
a. Press the "timer off" key (8) to display "timer off".
the time flashes.
b. Press the "temP" keys (4) until the value "3:00" is set near to the "timer off" indicator.
c. Press the "timer on" key (7) to display "timer on".
the time flashes.
d. Press the "temP" keys (4) until the value "10:00" is set near to the "timer on" indicator.
e. Wait 3 seconds, the time set will stop flashing and the function will be active.
TIMER ON > TIMER OFF (figures "33", "34" and "40")
(on => Stop => Start functioning)
this function is useful if the air conditioner is to be switched on before getting up and switched off after
leaving home.
Example:
the time is 20:00. if the air conditioner is to be switched on at 06:00 the next morning and switched of at 08:00.
a. Press the "timer on" key (7) to display "timer on".
the time flashes.
b. Press the "temP" keys (4) until the value "10:00" is set near to the "timer on" indicator.
c. Press the "timer off" key (8) to display "timer off".
the time flashes.
d. Press the "temP" keys (4) until the value "12:00" is set near to the "timer off" indicator.
e. Wait 3 seconds, the time set will stop flashing and the function will be active.
4 - MAINTENANCE AND CLEANING
Before proceeding with any maintenance and cleaning, always make sure the sys-
tem has been switched off, using the remote control, and the power supply plug
has been disconnected from the system socket (or the upstream master isolating
switch is positioned at "0" OFF).
Do not touch the metal parts of the unit when removing the air filters.
They are very sharp. Cuts or injury risk.
4.1 - CLEANING
4.1.1 - Cleaning the indoor unit and remote controller
Use a dry cloth to clean the indoor unit and the remote control.
a cloth dampened in cold water can be used to clean the indoor unit if it is very dirty.
EN - 34