Olimpia splendid OS-SEPHH09EI Mode D'emploi Et D'entretien page 86

3.5.3 - Functioning in Cooling/Heating/Fan only mode (figure 34)
START
Check that the unit is connected and is powered electrically.
a. Press key "moDe" (1) to select the desired mode.
b. Set the desired temperature by pressing the "temP" keys (4).
normally the temperature is between 16-30 °C/ 60-86 f (20-28 °C/68-82 f).
c. When the remote control is "off", press the "on/off" key (2) to start the air conditioner.
d. Press key "fan" (7) to select the desired speed.
e. When the remote control is "off", press the "on/off" key (2) to start the air conditioner.
the fan onlY mode does not adjust the temperature, therefore, to select this mode, only perform the "a",
"c", "d", "e" phases.
STOP
a. Press the "on/off" key (2) to stop the air conditioner.
if the aUto mode is not wanted, the desired conditions can be selected manually.
3.5.4 - Functioning in dehumidification
START
Check that the unit is connected and is powered electrically.
a. Press the "moDe" key (1) to select "DrY" mode.
b. Set the desired temperature by pressing the "temP" keys (4).
c. When the remote control is "off", press the "on/off" key (2) to start the air conditioner.
STOP
a. Press the "on/off" key (2) to stop the air conditioner.
Fan speed cannot be adjusted when the unit is in AUTO and DRY modes.
3.5.5 - Breeze Away function
This function avoids that the air flow is direct in order to create a fresh breeze.
This function is only available in COOL, FAN and DRY mode.
3.5.6 - Active Clean function
• in aCtiVe Clean mode, the air conditioner automatically cleans and dries the evaporator and keeps it
fresh for successive use.
the function is used on switch off of cooling mode to clean the evaporator and keep it fresh for successive
use.
this function is easy to activate and accessible from the remote control.
• the air conditioner will operate as follows:
- fan only mode with fan at low speed (13 minutes) -
- Heating with fan at low speed (1 minute)
- fan only operation (2 minutes)
- Stop operation
- Unit switch-off.
This function is only available in COOL (AUTO COOL, FORCED COOL) and DRY modes.
Before selecting this function, it is recommended to start the air conditioner in cooling mode for
approx. 30 minutes.
Once the function is activated, all timer settings will be annulled.
EN - 30