Olimpia splendid OS-SEPHH09EI Mode D'emploi Et D'entretien page 85

9. BREEZE AWAY key
Press this key to activate the function.
The function activates only with the mode COOL, FAN and DRY.
10. TURBO key
Press this key for less than 2 seconds to start the tUrBo function.
11. LED key
Press this key to activate or deactivate the leD display of the indoor unit and the buzzer of the air con-
ditioner (depending on the model) to create a comfortable and silent environment.
12. ACTIVE CLEAN key
if the key is held down for more than 2 seconds, the aCtiVe Clean function is activated.
3.5 - FUNCTIONS
3.5.1 - Automatic operation
When the air conditioner is put in "aUto" mode, these will automatically select cooling, heating or fan,
depending on the temperature that has been selected and the room temperature.
once the operational mode has been selected, the functioning conditions are stored in the memory of the
unit microcomputer and the air conditioner starts to function in the same conditions, when simply pressing
the "on/off" key of the remote control.
START
Check that the unit is connected and is powered electrically.
a. Press the "moDe" key (1) to select "aUto" mode.
b. Set the desired temperature by pressing the "temP" keys (4).
normally the temperature is between 16-30 °C/ 60-86 f (20-28 °C/68-82 f).
c. When the remote control is "off", press the "on/off" key (2) to start the air conditioner.
STOP
a. Press the "on/off" key (2) to stop the air conditioner.
if the aUto mode is not wanted, the desired conditions can be selected manually.
When aUto mode is selected, the fan speed does not have to be set; the fan speed is controlled
automatically.
3.5.2 - Manual operation (figure 41 and 42)
manual operation can be used temporarily if the remote control cannot be found or its batteries are discharged.
a. Open and lift the front panel to an angle in which it blocks and a "click" is heard (figure 41).
b. Press the control key once (AUTO/COOL) to start operation in "AUTO" mode (figure 42).
c. Close the panel well, taking it back to its original position (figure 46).
• By pressing the manual key, the operating passes in sequence to:
AUTO > COOL > OFF.
• Press the key twice to start the unit in forced "COOL" mode.
This mode must be used for the inspection only.
• By pressing the key a third time. operation stops and the air conditioner switches off.
• To restore remote control operation, use the remote control directly.
EN - 29
PHENIX E INVERTER