SilverCrest 379528 2110 Guide Abrégé page 12

Removing the blender
If you want to remove the blender 3 from the motor block 6:
1) Always start by setting switch 5 to the off position ("0") and pulling out the
mains plug.
2) Wait until the motor has come to a complete standstill before lifting the
blender 3 off the motor block 6. Remove the blender 3 from the motor
block 6 in a vertical, upward motion.
Cleaning
DANGER! ELECTRIC SHOCK!
Before starting to clean the blender and its components:
► Ensure that the motor is switched off and the power plug removed from the
socket.
Do not immerse the motor block 6 in water or other liquids. This could
result in you receiving a fatal electric shock and cause damage to the
appliance.
► Never open the housing of the appliance. Otherwise, there is a risk of a
fatal electric shock.
WARNING! RISK OF INJURY!
Handle the cutting blades 4 with extreme caution. They are extremely
►
sharp!
CAUTION! PROPERTY DAMAGE!
► Do not use solvents or abrasive cleaners on the plastic surfaces, they could
be damaged by them.
SSMC 600 B1
GB │ IE │
9 ■