Publicité
Les langues disponibles
Les langues disponibles
5.SET UP
HANDLE
1.Loosen the 4 bolts on the handle bracket.
2.Insert the right handle(throttle lever is attached)and the left handle assembly into
the braket and retighten the bolts securely.
(1)Handle bracket
(2)Right handle
(3)Bolt
(4)Left
(5)Engine side
SAFETY GUARD
Attach the safety guard to the gear care and fix it with the clump and 2 bolts (M5X25)securely
THROTTLE WIRE
WARNING
After fitting up the handle make sure that the throttle cable is put in the throttle
lever.if not,it is very dangerous because the engine rotate after releasing the
throttle lever.
ADJUSTING THE THROTTLE CABLE
2. If the play is short or long, take off the air cleaner cover, loosen the lock nut
and adjust the play.
INSTALLING THE MYLON CUTTER
1.Set correctly the inner holder and the outer holder to the gear shaft.
2.Screw the attached bold(M8 Left) into the gear shaft and secure it with the spanner.
3.Screw the nylon cutter into the bolt by fixing the inner holder with the L-shaped bar and tighten it manually.
NOTE
Keep bolts and washers to install the blade carefully so as not to lose them.
73
Publicité
