Publicité
Les langues disponibles
Les langues disponibles
LIVARNO HOME LSLB 100 A2
6.2 The right place for mounting
Select a location carefully and prepare well before mounting.
Arrange all the individual parts, tools required and fittings tidily so everything is ready to hand.
The LED emitter (1) must only be mounted on stable surfaces such as walls.
The power supply must be via the building's electrical circuit.
Do not mount the LED emitter (1) above a heat source or in the immediate vicinity of other light
sources. When choosing the right place for mounting, please also note the illustrations [D and E] on
the cover page.
Select the location so that the LED emitter (1) is protected from wind, rain and dirt.
Find out in advance what fittings are suitable for the location you have chosen. Suitable fittings for
mounting the LED emitter (1) on concrete are provided.
6.3 Tools required
The following tools are not supplied. This list is a guide only. The actual tools you will require depend on
the individual location.
Ladder
Voltage tester
Spirit level, folding rule, pencil
Drill with 8 mm stone/concrete bit
Phillips screwdriver, flat screwdriver
Open-jawed spanner (gap 12 mm), combination pliers, wire cutters
6.4 Before mounting
DANGER! The unit must only be mounted by an authorised electrical engineer! The power
supply must be via the building's electrical circuit.
DANGER! The power must be switched off during the mounting process!
WARNING! When drilling holes, make sure there are no cables in the walls.
Before mounting the LED emitter (1), make sure you are familiar with all its individual parts and read
and observe the instructions and diagrams in these operating instructions.
Make sure that the cable to which the LED emitter (1) is to be connected is not live. To do this, remove
the fuse for the relevant power circuit or switch the circuit breaker to the "0" position in your fusebox.
Make sure that you also test that the cable is not live using a voltage tester!
8 - English
Publicité
