Dometic SinePower MSI 1812T Instructions De Montage Et De Service page 8

Safety instructions
• Maintenance and repair work may only be carried out by qualified
personnel who are familiar with the risks involved and the relevant
regulations.
2.2 Safety when installing the device
!
WARNING!
• Never connect more than one consumer device to the inverter. If you
connect more than one device, a short circuit may occur.
• Take the precautions necessary to ensure that children cannot inter-
fere with operation.
Dangerous situations may occur which cannot be recognised by
children!
!
CAUTION!
• Ensure the device is standing firmly.
The device must be set up and fastened in such a way that it cannot tip
over or fall down.
A
NOTICE!
• Do not expose the device to a heat source (such as direct sunlight or
heating). Avoid additional heating of the device in this way.
Electrical cables
!
CAUTION!
• Lay the cables so that they cannot be tripped over or damaged.
A
NOTICE!
• If cables have to be fed through metal walls or other walls with sharp
edges, use ducts or wire bushings to prevent damage.
• Do not lay cables which are loose or bent next to electrically conduc-
tive material (metal).
• Do not pull on the cables.
• Do not lay the 230 V mains cable and the 12/24 V DC cable in the
same duct.
• Fasten the cables securely.
8
SinePower
EN