Parkside PWSA 20-Li D4 Traduction Des Instructions D'origine page 43

Cleaning
Do not use any cleaning agent or
solvent.­Chemical­substances­can­
etch the plastic parts of the device.
Never clean the device under run-
ning water.
•­ Thoroughly­clean­the­device­after­every­
use.
•­ Clean­the­ventilation­openings­and­the­
surface of the device with a soft brush
or cloth.
Storage
• Store the appliance in a dry place well
out of reach of children.
•­ Cutting­discs­must­be­dry­and­stored­
upright and should never be stacked.
• Before prolonged storage, remove the
rechargeable battery from the device
and charge it fully.
•­ The­storage­temperature­for­the­rechar-
geable battery and the device is bet-
ween­0­°C­and­45­°C.­Avoid­extreme­
cold or heat during storage to ensure the
battery output is not adversely affected.
Disposal/environmental
protection
Remove the battery from the device and re-
cycle the device, battery, accessories and
packaging in an environmentally-friendly
manner.
Electrical devices do not belong in
domestic waste.
Do not throw batteries into domestic
waste,­fi ­ re­(risk­of­explosion)­or­wa-
ter. Damaged batteries can harm
the environment and your health if
poisonous fumes or liquids escape.
Dispose of the batteries according to local
standards. Defective or used batteries must
be recycled in accordance with Directive
2006/66/EC.­Hand­in­the­batteries­at­a­
used battery collection point where they
are recycled in an environmentally friend-
ly manner. For more information, please
contact your local waste management pro-
vider or our service centre.
Dispose of batteries in a discharged state.
We recommend covering the contacts with
an adhesive strip to protect against short
circuits. Do not open the battery.
Directive 2012/19/EU on waste electrical
and­electronic­equipment:­Consumers­are­
legally obliged to recycle electrical and
electronic equipment in an environmentally
sound manner at the end of its life. In this
way, environmentally friendly and resour-
ce-saving recycling is ensured.
Depending on the implementation in na-
tional law, you may have the following
options:
• Return to a shop,
•­ Hand­over­to­an­offi ­ cial­collection­
point,
• Return to the manufacturer/distributor.
This­does­not­affect­accessories­enclosed­
with the old devices or tools without any
electrical components.
GB MT
43