Parkside PWSA 20-Li D4 Traduction Des Instructions D'origine page 40

GB MT
Removing the attachment
1. If necessary, remove the disc for better
access, see "Installing/changing disc".
2. Release the attachment (11) by pushing
the notch (17) away from the guard
cover (7).
3. Unscrew the attachment (11) from the
guard cover (7).
Installing/changing disc
1. Press the spindle stop button (9).
2.­ Turn­the­mounting­spindle­(14)­until­the­
spindle­lock­fi ­ xed­the­mounting­spind-
le. Keep and continue to hold down
the spindle lock button (9)
3. Release the clamping nut (13) with the
chuck key (10). You can release the
spindle lock button (9).
4. Set the desired disc onto the mounting
fl ­ ange­(
12). label on the disc
should always face the device.
If the rotary direction is in-
dicated on your disc, ensure
that it corresponds to the
rotary direction of the angle
grinder when mounting. This
is indicated on the device
below the spindle stop but-
ton (9) (
­ Ensure­that­the­fl ­ ange­(
placed on the device in such a way
that­the­recesses­in­the­fl ­ ange­grip­
into­the­edge­of­the­device.­The­
mounting spindle (14) must turn simul-
taneously­when­you­turn­the­fl ­ ange.­
5. Set the clamping nut (13) on the moun-
ting­spindel­(14)­again.­The­fl ­ at­side­of­
the clamping nut must face the attach-
ment tool if the thickness of the disc
receptor is < 5 mm.
40
).
12) is
If the thickness of the disc receptor is
≥­5­mm,­turn­the­clamping­nut.
See illustration
6. Press the spindle stop button (9) and
turn the mounting spindle (14), until the
spindle toggle button holds the spind-
le­fl ­ ange­in­a­fi ­ xed­position.­Pull­the­
clamping nut (13) tight again using the
chuck key (10). You can let go of the
spindle lock button (9).
Installing/changing the
wire brush
1. Press the spindle stop button (9).
2.­ Turn­the­mounting­spindle­(14)­until­the­
spindle stop button holds the mounting
spindle­in­a­fi ­ xed­position.­Keep­the­
spindle stop button (9) depressed.
3. Release the wire brush with a combina-
tion wrench (not included in the scope
of delivery). You can now release the
spindle stop button (9).
4. Place the desired wire brush onto the
mounting spindle.
5. Press the spindle stop button (9) and
rotate the wire brush on the mounting
spindle­(14).­Tighten­the­wire­brush­
using a combination wrench. You can
now release the spindle stop button (9).
Operation
Caution! Risk of injury!
- Remove the battery before carrying out
any work on the device.
- Only use cutting/grinding discs and ac-
cessories recommended by the manufac-
turer. Using other attachment tools and
other accessories can represent a risk of
injury for you.
- Only use accessory parts which bear
information about the manufacturer, type
.