Parkside Performance PPKSA 40-Li B2 Traduction Des Instructions D'origine page 58

GB MT
Maintenance and
cleaning
Maintenance and cleaning
work must always be carried
out with the motor switched
off and the batteries removed.
Danger of injury!
Leave any maintenance and servic-
ing work not covered by this man-
ual to our Service-Center. Use only
original spare parts.
Allow the machine to cool down
before all maintenance and clean-
ing works. Danger of burn injuries!
Use cut-protection gloves
when handling the chain or
the chain bar. Risk of cuts!
Switch off the device and remove
the battery before carrying out any
maintenance work.
Cleaning
• Clean the machine thoroughly after
every use. In this way, you extend the
life of the machine and avoid accidents.
• Keep the gripping handles free of pet-
rol, oil or grease. Clean the gripping
handles, where appropriate, with a
moist cloth soaked in soap. Use no sol-
vents or petrol for cleaning!
• Clean the saw chain after every use. Use
a paint brush or wipe for that. Do not use
any liquids to clean the chain. After clean-
ing, oil the chain lightly with chain oil.
• Clean the ventilation slots and the
surfaces of the machine with a paint
brush, whisk or dry cloth. Do not use
any liquids for cleaning.
58
Maintenance intervals
Regularly carry out the maintenance opera-
tions listed in the following table.
The life of the saw is extended by regular
maintenance of your chainsaw.
Furthermore, you get optimum cutting per-
formance and avoid accidents.