Parkside Performance PPKSA 40-Li B2 Traduction Des Instructions D'origine page 52

GB MT
3. Release the chain brake, where you
shift the brake arm (5) back against the
front grip (4).
4. Hold the chainsaw firmly with both
hands, with the right hand on the rear
grip (1) and the left hand on the front
handle (4). Thumb and finger must
close securely over the handles.
5. To activate the device, first press the
button for the charge level indicator
( 26).
6. To start the device, push the switch lock
(3) forwards with the right thumb and
press the on/off switch (2). Release the
switch lock (3).
7. The power saw switches off when you
release the On/Off switch (2) again.
Switching for continuous running is not
possible.
Overload indication
In case of overload, the red and yellow
LEDs of the charge level indicator (
flash.
Battery charge level
indicator
Press the button for the charge
status display (
the control panel light up.
The charge level of the batteries is indi-
cated by illumination of the corresponding
LED lights of the battery charge level indi-
cator ( 24).
3 LEDs illuminated (red, orange and green):
Battery charged
2 LEDs illuminated (red and orange):
Battery partially charged
1 LED illuminated (red):
Battery needs to be charged
52
24)
26). The LEDs on
Changing the chain
speed
By pressing the button for chain speed se-
lection (27) you can switch between chain
speeds 15 and 20 m/s.
You can see at which chain speed the de-
vice is currently working by illumination of
Levels 1 or 2 on the chain speed indicator
(25).
Level 1: 15 m/s
At Level 2, the chain speed is 25
m/s if you use the device with two
8 Ah performance batteries "Smart
PAPS 208 A1".
Checking the chain
brake
The motor cannot be turned on if the
chain brake has engaged. Do not
employ the chain brake in order to
start the chainsaw or to switch it off.
Method 1:
1. Place the chainsaw onto a solid, flat
surface. It must not contact any objects.
2. Operate the chain brake lever (5).
3. Insert the batteries (16) into the device.
A warning tone sounds. A warning
tone sounds.
The chain brake functions.
4. Loosen the chain brake.
Method 2:
1. Place the chainsaw onto a solid, flat
surface. It must not contact any objects.
2. Operate the chain brake lever (5).
3. Hold the chainsaw firmly with both
hands, with the right hand on the rear
handle ( 1) and the left hand on the
front handle (
Level 2: 20 m/s
4). Thumb and finger