Parkside Performance PPKSA 40-Li B2 Traduction Des Instructions D'origine page 54

GB MT
• Always switch off the chainsaw motor
before moving from one tree to another.
• Lay the connecting lead such that it will
not be caught on branches or similar
during sawing.
• For each cut, apply the claw stop se-
curely and only then start sawing.
• You have better control when you saw
with the bottom side of the chain bar
(with pulling saw chain) and not to with
the top side of the chain bar (with push-
ing saw chain).
• The saw chain must not contact either the
ground or another object during sawing
through or after sawing completion.
• Make sure that the saw chain does not
become jammed in the wood. Do not
let the tree trunk break or split off.
• Consider also the precautions against
spring-back (see notes on safety)..
• For sawing work on a slope, always
stand above the tree trunk. To keep
control at the moment of "sawing
through", reduce the contact pressure
at the end of the cut without loosening
the firm grip on the chainsaw handles.
Ensure that the saw chain does not
come into contact with the ground.
After completing the cut, wait for the
chainsaw to come to a standstill before
removing the chainsaw. Always switch
off the chainsaw motor before moving
from one tree to another.
If the saw chain jams, you
do not attempt to pull out the
electric chainsaw using pow-
er. There is a danger of injury
here. Switch off the motor
and use a lever or wedge to
free the electric chainsaw.
54
Bucking
This refers to sawing up a felled tree trunk
into smaller sections.
Ensure that you are in a secure position
and that your body weight is distributed
evenly on both feet. If possible, under-
pin and support the stem with branches,
beams or wedges.
• Ensure that the saw chain does not
come in contact with the ground during
sawing.
• Make sure you have a secure stance
and, in the case of sloping ground,
stand above the log.
To maintain full control at the moment
of "sawing through", reduce the contact
pressure at the end of the cut, without
releasing the firm grip on the chain saw
handles. Once cutting is complete, wait
for the saw chain to come to a standstill
before removing the chain saw from
there. Always switch off the chain saw
before changing from tree to tree.
1. Log is lying on the ground:
Saw through the log completely from
above and ensure at the end of the cut not
to contact the ground.
If you can turn the tree trunk, saw two-
thirds of the way through it. Then turn the
trunk around and saw the rest of the way
through from above.
2. Log is supported at one end:
Start sawing from the bottom and work your
way up (with the upper edge of the bar)
a third of the way into the diameter of the
trunk to prevent splitting. Then saw from the
top downwards with the lower edge of the
bar towards the first cut to prevent the bar
from becoming jammed in the wood.