Parkside Performance PPKSA 40-Li B2 Traduction Des Instructions D'origine page 49

Charging the battery
If warm, allow the battery to cool be-
fore charging. Charge the battery
(16) when only the red LED on the charge
level indicator (
1. If necessary, remove the batteries (16)
from the tool.
2. Slide the batteries (16) into the char-
ging slot of an X 20 V Team charger
from PARKSIDE.
3. Plug the charger into a socket.
4. Once charging is complete, disconnect
the charger from the mains supply.
5. Remove the batteries (16) from the
charger.
Overview of the LED indicators on
the charger:
Green LED illuminated while battery not
inserted: Charger is ready.
Green LED lights up: Battery is charged.
Red LED lights up: Battery charging.
Red LED flashes: Overheated
Red and green LED flash:
Battery defective
Assembly
Always wear protective
gloves when working with
the chainsaw and employ
only original parts. Pull out
the power plug before doing
any work on the chainsaw
itself – injury hazard!
Before putting the electric chain saw into
operation, you must:
- adjust the saw chain tension,
- pour in chain oil,
- charge and insert both batteries
- check the function of the chain brake
and the automatic oil pump.
24) is illuminated.
Mounting the saw chain
and blade
Switch off the device and remove
the battery before carrying out any
maintenance work.
1. Lay the saw on a flat surface.
2. Turn the fastening bolt (11) anti-
clockwise (
sprocket chain wheel covering (13).
3. Spread out the saw chain (6) in a loop
so that the cutting edges are aligned in
a clockwise direction. Use the symbol
below the chain sprocket (20) as a gui-
de to align of the saw chain (6).
4. Slide the saw chain (6) into the bar
guide groove. To mount the guide bar
(4), raise it to an angle of approx.
45 degrees. This will make it easier
to replace the saw chain (6) onto the
sprocket (20).
5. Place the chain bar (7) and saw chain
(6) on the bar bolts (19). When the pin
(19a) to the right of the coach screw
(19) sits in the slotted recess on the
blade, the blade is placed correctly.
It is normal that the saw chain (6) is
slack.
6. Position the sprocket chain wheel cover-
ing (13). The chain tensioner pin (21)
on the inside of the sprocket cover (13)
must be guided into the chain tension
pin holder (22).
7. Slightly tighten the mounting screw (11)
of the sprocket cover (
8. Pre-tension the saw chain (6) by turning
the screw for the chain quick-tensioning
system (12) in clockwise direction.
9. Tighten the fastening bolt (11) (
GB
) to remove the
Direction of travel of the
saw chain
) .
MT
).
49