Parkside Performance PPKSA 40-Li B2 Traduction Des Instructions D'origine page 40

GB MT
Technical Data
Cordless chainsaw 40 V
.............................. PPKSA 40 Li B2
Rated input voltage
(direct voltage); (2 x 20 V)
U ... 40 V
Motor current I ................................16 A
Protection category...........................IPX0
Chain speed
v ........................... 15 m/s or 20 m/s
0
v ........................................25 m/s
max
Weight (without saw chain,
blade bar, bade encasing, oil,
rechargeable batteries) ... approx. 3.17 kg
Oiltank ...................................... 180 ml
16" Chain bar . Trilink M1431656-1041TL
Chain ......................... Trilink CL14356TL
Chain pitch .............. 3/8" (9.525 mm)
Chain link separation ............... 10 mm
Chain width ........................... 1.1 mm
Number of driving elements ............ 56
Teeth of the sprocket chain wheel ....... 6
Length of the chain bar .455 mm/45,5 cm
Sawing length ... approx. 380 mm/38 cm
Temperature..........................max. 50 °C
Operation ......................... -20 - 50 °C
Storage ................................ 0 - 45 °C
Acoustic pressure level
) ....................... 90.5 dB; K
(L
pA
Sound power level (L
measured ......... 99.8 dB; K
guaranteed .............................103 dB
Vibration
) ......... max. 1.76 m/s
(a
h
Type of battery ............................... Li-Ion
For use with smart batteries
(Smart PAPS 204 A1/Smart PAPS 208 A1)
Operating frequency/
Frequency band ....2400 - 2483.5 MHz
Max. transmission power ...... ≤ 20 dBm
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration of
conformity.
40
= 3 dB
pA
)
WA
= 3.29 dB
WA
; K= 1.5 m/s
2
The specified total vibration value and the
stated noise emission value have been
measured according to a standardised test
method and can be used to compare one
power tool with another.
The specified total vibration value and the
stated specified noise emission value can
also be used for a provisional assessment
of the load.
Warning: The vibration and noise
emissions may deviate from the
specified values during actual use of the
power tool, depending on how the power
tool is being used and, in particular, what
kind of material is being worked on.
Safety measures for the protection of the
operator are to be determined that are
based on an estimate of the actual vibra-
tion load under the real operating condi-
tions (for this, all parts of the operating
cycle are to be taken into account, for
example, times in which the electric tool
is turned off, and those during which it is
turned on but running without a load).
Charging times
The device is part of the X 20 V TEAM
series from Parkside and can be operated
using batteries of the X 20 V TEAM series
from Parkside. Batteries of the X 20 V
TEAM series may only be charged using
chargers of the X 20 V TEAM series.
2
The charging time is influenced
by factors such as the tempera-
ture of the environment and the
battery, as well as the mains volt-
age applied, and may therefore
deviate from the specified values.