Elcometer MTG2 Guide D'utilisation page 18

13 TECHNICAL SPECIFICATION (continued)
Model
e
Battery Life
Gauge Weight
Gauge Dimensions
Can be used in accordance with: ASTM E 797, EN 14127, EN 15317
14 LEGAL NOTICES & REGULATORY INFORMATION
Declaration of Conformity – CE
The Elcometer MTG2 & MTG4 comply with the requirements of the following EU Directives:
2014/30/EU EMC Directive
2011/65/EU Restriction of the Use of Certain Hazardous Substances in Electrical and
Electronic Equipment (RoHS) Directive
The Declaration of Conformity (CE) is available to download via:
https://downloads.elcometer.com/Declaration_of_Conformity/English/DoC_MTG2_MTG4.pdf
Declaration of Conformity – UKCA
The Elcometer MTG2 & MTG4 comply with the requirements of the following UK Standards:
S.I. 2016 No. 1091 Electromagnetic Compatibility Regulations 2016
S.I. 2012 No. 3032 Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment (RoHS)
Regulations 2012
The Declaration of Conformity (UKCA) is available to download via:
https://downloads.elcometer.com/Declaration_of_Conformity/English/DoC_MTG2_MTG4_UKCA.pdf
The USB is for data transfer only and is not to be connected to the mains via a USB mains adapter.
The ACMA compliance mark can be accessed via: Menu/About/Legal/Regulatory
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
-- Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by Elcometer Limited could void the user's authority to operate the equipment under FCC rules.
This Class B digital apparatus complies with CAN ICES-3 (B)/NMB-3(B).
and ElcoMaster are registered trademarks of Elcometer Limited, Edge Lane, Manchester,
R
M43 6BU. United Kingdom
All other trademarks acknowledged.
This product is packed in a cardboard package. Please ensure that all packaging is disposed of in an environmentally sensitive
manner. Consult your local Environmental Authority for further guidance.
Head-Office: Elcometer Limited, Edge Lane, Manchester, M43 6BU, United Kingdom.
e
When in continuous reading mode at a reading rate of 4 Hz, using alkaline batteries. Lithium or
rechargeable batteries may differ.
www.elcometer.com
145 x 73 x 37mm (5.7 x 2.87 x 1.46")
®
MTG2
Approximately 15 hours
210g (7.4oz)
including batteries, without transducer
without transducer
R
MTG4
en-16