ProBreeze PB-20 Mode D'emploi page 6

1. Press the humidity button to cycle through the humidity setting options.
2. These will increase in 5% increments from 30% to 80% and will be displayed on the LED
screen.
3. If the room humidity is at or above the set humidity, the dehumidifier will begin working.
4. If the room humidity is lower than the set humidity by 5%, the compressor will stop but the
fan will remain on.
Continuous Mode:
When in continuous mode, the dehumidifier will run regardless of the room's humidity
percentage. The change the fan speed, follow the below steps:
1. The default fan speed is high. Press the fan button to cycle through the fan options of low
and high.
2. The corresponding indicator light will light up.
Internal Drying:
Internal drying can help prevent mould caused by damp from forming inside your dehumidifier.
1. Press the internal drying button to start internal drying.
2. The dehumidifier will run at high fan speed for 30 minutes and then low fan speed for 20
minutes.
3. Press the internal drying button again to resume normal dehumidification.
Note: Complete internal drying before storing the appliance.
Child Lock:
Activate child lock to deactivate all buttons on the control panel.
1. Hold down the mode button for 3 seconds to activate child lock.
2. Hold down the mode button for 3 seconds to deactivate child lock.
Emptying the Water Tank:
When the water tank is full, the water tank indicator light will illuminate and the dehumidifier will
beep 10 times, then turn off.
1. Unplug the dehumidifier and place it on a flat, stable surface.
2. Firmly grip each side of the water tank and gently pull it out of the dehumidifier.
3. Remove the water tank cover.
4. Gently tip the water tank to empty it.
5. When empty, replace the water tank cover and slot the water tank back into the appliance.
Note: The water tank indicator light will also turn on if the dehumidifier is on, but the tank is
missing or placed in incorrectly.
Setting Up Continuous Drainage:
10 of 92 | English
1. Unscrew the cover and pull out the plug from the continuous drainage hose outlet.
2. Connect the continuous drainage hose to the outlet.
3. Ensure the end of the hose is at least 10cm lower than the height of the continuous drainage
outlet.
WIFI AND SMART LIFE SET UP
- -
Smart Life is a centralised app for smart device management. With Smart Life, you can control
your smart devices remotely and set up a complex chain of commands and automations. To
connect this dehumidifier to a smartphone via Wi-Fi throughthe Smart Life app, follow the below
steps.
Note: Ensure WiFi network is set to 2.4GHz.
• Download the Smart Life app by Tuya Inc from the Apple App Store or Google Play Store.
• Register for a Smart Life account.
• Log into the Smart Life app.
• On the Home page tap Add Device or the "+" symbol in the top right hand corner.
• Tap Small Home Appliances.
• Tap Dehumidifier.
• Plug in the appliance and ensure the power socket is turned on.
• Press the power button to turn on the appliance and then press the power button again to
turn off the appliance and place it in standby mode.
• Press and hold the humidity button for three seconds to activate the appliance's WiFi
pairing function. After three seconds the WiFi indicator light will begin to blink.
• In the Smart Life app, tap "Confirm WiFi Indicator Light Rapidly Blinking."
• Input your WiFi password and tap "Confirm".
• The Smart Life app will automatically connect to the appliance and show "Successfully
Added Device"
• Return to the Smart Life app home page and tap the appliance's name.
• Use the controls to fully control the appliance and set desired settings etc.
• After successfully paired up with Smart-Life app, the dehumidifier is ready to connect with
English | 11 of 92