ProBreeze PB-20 Mode D'emploi page 5

PARTS
- -
1
3
2
4
10 11
15
Body:
1. Control Panel
2. Water Tank Cover
3. Water Tank Handle
4. Water Tank
5. Handle
6. Filter
7. Continuous Drainage Hose Outlet
8. Power Cord Storage
9. Cater Wheels
8 of 92 | English
12
14
13
16 17
18
Control Panel:
10. Timer Button and Indicator Light
11. Fan Button and Indicator Light
12. Water Tank Indicator Light
13. Humidity Button
14. WiFi Indicator Light
15. Internal Drying Button and Indicator Light
16. LED Display
17. Mode Button and Indicator Lights
18. Power Button
Getting started
• Ensure the water tank is completely empty.
5
• Ensure all windows and doors are shut in the room where the dehumidifier is in use.
• Set up the dehumidifier so that there is at least 50cm space above the dehumidifier and
20cm around all sides.
6
OPERATING INSTRUCTIONS
- -
Turning On/Off:
7
1. Plug in the dehumidifier.
2. To turn on the dehumidifier, press the power button. The dehumidifier will beep once and
the power indicator light will turn on.
3. To turn off the dehumidifier, press the power button again. The power indicator light will turn
8
off.
9
Setting a Timer:
The timer can be set to automatically turn the dehumidifier on or off.
Setting a Timer for Turning On:
1. While the dehumidifier is plugged in but not turned on, press the timer button repeatedly to
cycle through the timer options of 1 to 24 hours, increasing in increments of an hour.
2. The number of hours will display on the LED screen.
3. To set a number of hours, do not touch any button for 5 seconds.
4. The dehumidifier will turn on when the timer elapses.
Setting a Timer for Turning Off:
5. While the dehumidifier is on, press the timer button repeatedly to cycle through the timer
options of 1 to 24 hours, increasing in increments of an hour.
6. The number of hours will display on the LED screen.
7. To set a number of hours, do not touch any button for 5 seconds.
8. The dehumidifier will turn off when the timer elapses.
Setting the Mode:
1. Press the mode button continuously to cycle through the options of Auto Mode and
Continuous Mode.
2. The corresponding indicator light will light up.
Auto Mode:
When in auto mode, the default relative humidity is 50%. To change the relative humidity, follow
the below steps:
English | 9 of 92