Whirlpool MFGS8030RZ Guide D'utilisation page 21

4. Turn gas pressure regulator cap counterclockwise with a 5/8"
(1.6 cm) combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
A.
Plastic cover
B.
Gas pressure regulator cap with solid end facing out
C.
Gas pressure regulator cap with hollow end facing
out
D.
Washer
E.
Gas pressure regulator cap
5. Turn over the gas pressure regulator cap and reinstall on
regulator so that the hollow end faces out and the marking
"↓LP" is facing the direction shown in the above drawing.
6. Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners (Natural Gas to
Propane Gas)
1. Remove burner cap.
2. Remove the burner base.
A.
Burner cap
B.
Burner base
C.
Alignment pins
D.
Igniter electrode
E.
Gas tube opening
A.
Burner cap
B.
Burner base
A
B
Large Burner
3. Apply masking tape to the end of a 9/32" (7 mm) nut driver to
help hold the gas orifice spud in the nut driver while changing
it. Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out. Set gas orifice
spud aside.
A.
Igniter electrode
B.
Orifice spud
C.
Orifice spud holder
D.
Screws
4. Remove the orifice spuds shipped in the literature package in
the oven. Gas orifice spuds are stamped with a number and
have a groove in the hex area. Replace the Natural gas orifice
spud with the correct propane gas orifice spud.
A.
Refer to the following chart for correct Propane gas orifice
spud placement.
Propane Gas Orifice Spud Chart for Surface Burner
For WFGS7530R*
Placement Burner
Rating / Type
LF 13000
LR 7500
RF 13000
RR 4500
CTR 12000
For MFGS8030R*
Placement Burner
Rating / Type
LF 9500
LR 9500
RF 13000
RR 4500
CTR 10000
NOTE: Refer to the Tech Sheet located on the rear cover for the
applicable individual burner BTU rating per fuel type.
5. Place Natural gas orifice spuds in the orifice spud bag.
IMPORTANT: Keep the Natural gas orifice spuds in case of
reinstallation with Natural gas.
6. Replace the burner base.
Propane groove
Size (mm) ID Number
1.08 108AM
0.84 084AM
1.08 108AM
0.64 064AM
0.73 073AM
(2 orifices
provided)
Size (mm) ID Number
0.96 096AM
0.96 096AM
1.08 108AM
0.64 064AM
0.96 096AM
21