Publicité
Les langues disponibles
Les langues disponibles
Storing your generator
• Press the illuminated on/off switch and unplug the generator. Store the
electrical cord in its storage place – fig.21.
• Raise the retaining hoop over the iron until it locks into place (audible click) –
fig.2.
• Your iron is then safely retained on its base. Warning: do not touch the soleplate
while still hot.
• Slot the extension cord outlet in the notch (depending on model). Take the end
of the cord support and press to return the flexible part into the base.
• Store the steam cord in its slide storage place. Take it, fold it in two so as to
make a loop. Put the end of this loop in the slide storage place then push gently
until you see the end on the other side of the slide storage place –
• Leave the iron (and the iron rest) to cool down for 30 minutes.
• You can then put your steam generator away, carrying it by the handle –
A problem with your generator ?
PROBLEMS
The generator does not
come on and the thermostat
light and the on/off switch
are not illuminated.
Water runs out of the holes
in the soleplate.
Water streaks appear on the
linen.
White streaks come through
the holes in the soleplate.
Brown streaks come through
the holes in the soleplate and
stain the linen.
The soleplate is dirty or
brown and may stain the
linen.
All manuals and user guides at all-guides.com
CAUSES
The appliance is not switched on.
Water has condensed in the
pipes because you are using
steam for the first time or you
have not used it for some time.
The soleplate is not hot
enough.
Your thermostat is faulty: the iron is
not hot enough.
Your ironing board is saturated with
water because it is not suitable for use
with a steam generator.
Your boiler has a build-up of scale
because it has not been rinsed out
regularly.
You are using chemical descaling agents
or additives in the water for ironing.
Fabric fibres have accumulated in the
holes of the soleplate and are burning.
Your linen is not rinsed sufficiently or
you have ironed a new garment before
washing it.
You are ironing at too high a
temperature.
You are using starch.
fig.22.
fig.1.
SOLUTIONS
Check that your appliance is correctly plugged in
and press the illuminated on/off switch.
Press on the steam control button away from your
ironing board until the iron produces steam.
Decrease the steam output while ironing at low
temperature (steam output control dial on the
control panel). Wait for the thermostat light to go out
before activating the steam control button.
Contact an Approved Service Centre.
Check that your ironing board is suitable (see page 5).
Rinse out the boiler.
Never add this type of product in the water tank or
in the boiler (see page 5 for what water may be used).
Contact an Approved Service Centre.
Clean the soleplate with a non-metallic sponge.
Ensure linen is rinsed thoroughly to remove any soap deposits
or chemicals on new garments which may be sucked up by
the iron.
See our recommendations regarding temperature
control setting.
Always spray starch on the reverse side of the
fabric to be ironed.
GB
9
Publicité
